Fabdec Excelsior Slimline Indirect Unvented Cylinders
Indirect Cylinder - Heated via an external heat source such as a boiler. Also includes an electric immersion heater.
Unvented Cylinder - Pressurised unit, fed directly from mains water. No header tank required.
The Fabdec Excelsior Indirect Slimline is a unvented hot water cylinder suitable for use with an unvented systems boiler. The Indirect model also uses a 3kW electric immersion heater as a back up power source, and comes complete with a expansion vessel & unvented kit. This unvented cylinder will provide hot water at mains water pressure, and requires no cold water header tank.
- For use with a System boiler
- Slimline 500mm diameter
- Expansion vessel and unvented kit included
- Immersion heater - rated @ 3kW, 240V, single phase, incoloy 825, with thermostat and independent cut-out
- Thermal insulation - CFC/HCFC free, (ODP zero), 60mm fire retardant insulation GWP=1
- Outer casing - PLASTISOL
- Inner cylinder - Duplex stainless steel
- High performance finned heating coil
- Indirect thermostat - factory fitted twin thermostat with independent reset, 30-70°C
- Safety device - all units factory fitted with 7bar/90°C pressure & temperature relief valve
- Inlet/Outlet
- Primary flow and return connections
- EXCELSIOR inlet diffuser for optimal blending of cold and hot water
- Internal or external expansion
- 60mm insulation
- Pressure test - all cylinders tested to 15 bar
- Insulated T&P valve
- No anode required
- Approvals - BBA, CE, WRAS, KIWA, ISO and benchmark
- 25 year internal cylinder guarantee
- 1 year guarantee available on all components, see separate installation manual for further details
- Direct thermostat - element thermostat, nominal setting 60°C
- Cylinder range - 130, 150, 175, 215, 244 litre. Other capacities available on a bespoke basis
- Indirect model - fitted with 22mm diameter stainless steel high performance coil and 1 immersion heater
- Direct model - 80L fitted with 1 immersion heater - 130 - 305L fitted with 2 immersion heaters