Gledhill Stainless Lite Plus Direct Buffer Store Cylinders

Buffer vessels are simply a duplex stainless steel tank that contains a volume of water, increasing the overall volume of the heating distribution system. This extra volume of water is designed to absorb any extra heat generated by the heat pump in low load conditions.

If the building cannot absorb the extra heat generated the return temperature to the heat pump will increase and will potentially cause the heat pump to turn off. If the temperature drops in the water returning to the heating appliance, then it will turn itself back on. If this cycling occurs at a greater frequency than the minimum run time for the appliance, this is classed as short cycling. The aim of a buffer vessel is to remove the possibility of any short cycling of the heating appliance.

• Open vented duplex stainless steel cylinder in direct or indirect models
• Buffer stores increase the overall volume of the heating distribution system, and reduce the cycling of the heat pump
• Designed for use with either air source or ground source heat pumps
• ErP rating: B
• Indirect models for use with gas or oil boilers, utilise a high efficiency corrugated coil to maximise heat transfer

Deciding on the correct type of Cylinder is an important decision. After you determine that Heat Pump Cylinders deliver the correct answer then the Gledhill Stainless Lite Plus Direct Buffer Store Cylinder 210 Litre - PLUDR210B is no doubt worth adding to the shortlist.